exocad Partner
Secure SSL connection
Tel: +49 (0) 7123 9595 146
Easy shopping

Aidite cameo lithium disilicate glass-ceramic block (5 pcs)

Aidite cameo Glaskeramik-Blöcke B40, C14 und I12
From €52.50 *
SW11059

Prices plus VAT plus shipping costs

Translucency:

Größe:

Farbe:




Easy shopping
Secure SSL connection
Free hotline service
Shopping safely
Lithium disilicate for everyday chairside use. Aidite’s cameo glass ceramic is a lithium... more
Product information "Aidite cameo lithium disilicate glass-ceramic block (5 pcs)"

Lithium disilicate for everyday chairside use.

Aidite’s cameo glass ceramic is a lithium disilicate CAD/CAM block for chairside and laboratory fabrication. The block is milled in a pre-crystallised state and, following a crystallisation firing of around 20 minutes, achieves its final strength of 400 ± 60 MPa and its natural colour.

Choose between HT (high translucency) for naturally translucent restorations and LT (low translucency) for greater coverage, for example on discoloured abutments. For those who wish to work entirely without firing, the pre-crystallised cameo KrystaFree is available in the same category.

Technical data
MaterialLithium disilicate glass ceramic (SiO₂, Li₂O, Al₂O₃, K₂O, etc.)
Flexural strength400 ± 60 MPa (3-point)
FiringCrystallisation firing approx. 20 minutes after milling
TranslucencyHT (high) or LT (low)
Block sizesI12: 15.5 × 11 × 13 mm
C14: 18 × 13 × 15 mm
B40: 40 × 15 × 14 mm
ColoursVITA classical A1–D4 (16 shades), Bleach BL1–BL4
Pack5 blocks per colour and size
Crystallisation firing

Manufacturer’s specifications from Aidite for a ceramic furnace. Holding time: 2 minutes for veneers, inlays and single crowns; 6 minutes for bridges. Support the restoration with firing paste during firing and allow it to cool slowly in the air after firing.

ProgrammeStart / DryingHeatingFinal temperature / Holding timeCool to
Standard450 °C / 4 mins40 °C/min840 °C / 2 or 6 mins500 °C
Fast403 °C / 18 s90 °C/min to 820 °C (10 s), then 90 °C/min820 °C / 2 or 6 min700 °C

Painting and glazing can be carried out using low-temperature paints, such as Aidite Biomic. If you are milling with CEREC, select the ‘IPS e.max CAD’ material in the software and then crystallise in a conventional ceramic furnace. You can find the instructions for use and the CEREC guide under Downloads.

Indications

HT: Inlays, onlays, veneers, single crowns, partial crowns and three-unit bridges.
LT: Inlays, onlays, copings, full crowns and three-unit bridges.
The long B40 block is suitable for bridges.

  • High strength 400 ± 60 MPa
  • Simple, rapid crystallisation firing
  • Good adhesive retention
  • Low abrasion on the natural antagonist

Preparation: Shoulders rounded or bevelled on the inside, no sharp edges; allow approximately 1 mm of space at the incisal edge for finishing. Minimum layer thicknesses for each indication are specified in the instructions for use.

The blocks have a metal holder with a pin and are therefore compatible with standard wet milling machines, such as the DGSHAPE DWX-43W.