exocad Partner
Secure SSL connection
Tel: +49 (0) 7123 9595 146
Easy shopping

Aidite cameo KrystaFree glass-ceramic block (5 pcs)

Aidite cameo KrystaFree Glaskeramik-Blöcke
Aidite cameo KrystaFree Farben
cameo KrystaFree Randstabilität
     
€99.95 *
SW11058

Prices plus VAT plus shipping costs

Farbe:




Easy shopping
Secure SSL connection
Free hotline service
Shopping safely
Milling. Polishing. Done. cameo KrystaFree is a CAD/CAM block made of lithium glass ceramic... more
Product information "Aidite cameo KrystaFree glass-ceramic block (5 pcs)"

Milling. Polishing. Done.

cameo KrystaFree is a CAD/CAM block made of lithium glass ceramic with a nanoscale, interlocking microstructure. The block is already crystallised – no crystallisation or sintering is required. After milling, the restoration is simply polished and can be fitted straight away. A single crown can thus be milled in around 15 minutes.

The consistently stable marginal edge reduces microleakage and thus the risk of secondary caries. With a flexural strength of 380 MPa, KrystaFree is suitable for chairside and laboratory fabrication using the wet milling process, for example on the DGSHAPE DWX-43W.

Technical data
MaterialLithium glass ceramic, pre-crystallised
Flexural strength380 MPa
Coefficient of thermal expansion (25–500 °C)10.5 ± 0.5 × 10⁻⁶ K⁻¹
Chemical solubility< 40 µg/cm²
Density2.47 ± 0.05 g/cm³
TranslucencyST – ultra-high (can be reduced by firing, if required)
Block size18 × 13 × 15 mm
Firingnot required – polishing is sufficient
ColoursA1, A2, A3, A3.5, B1, C1, D2, Bleach BL1, BL1, BL3
Pack5 blocks per colour
Indications and benefits

Indications: Veneers, inlays, onlays, partial crowns, and anterior and posterior crowns.

  • No sintering or crystallisation firing; short fabrication time
  • No shrinkage, no warping during glazing and firing
  • Stable edges, no chipping during milling
  • Good adhesive bonding, minimal wear on the antagonist tooth

Preparation: Shoulders rounded or bevelled on the inside, no sharp edges; allow approximately 1 mm of space at the incisal edge for finishing. For finishing, Aidite recommends the cameo KrystaFree polishing kit – unsuitable grinders may cause edge marks or overheating.

Firing instructions (optional)

Firing is not necessary – polishing is sufficient. If you wish to stain or glaze, this can be done in a single firing, for example using Aidite Biomic Stain/Glaze. A crystallisation firing is also available for reduced translucency.

FiringStartHeatingFinal temperature / holding timeOpen
Glaze/stain firing (example: Aidite kiln)450 °C55 °C/min730 °C / 1 min – max. 780 °C, otherwise translucency decreases600 °C
Crystallisation firing for reduced translucency450 °C, dry for 2 min50 °C/min840 °C / 3 minsbelow 600 °C

Etch the veneers with 4.5% hydrofluoric acid for 90–120 seconds prior to adhesive bonding. The full processing instructions can be found under Downloads.

Workflow

Scan and design, wet milling, polish – no furnace required and no waiting time for the crystallisation firing.

cameo KrystaFree Workflow